Hello everyone, I'm Xiaobian. Today, I will introduce the installation process of dimming glass. The following content is organized by Xiaobian for reference.Dimming glass1. Before installation, we must first customize the frame around the glass at the place where the glass is installed according to the original building structure. Drill a hole in the middle of the upper slot of the frame, about halfway through the glass. If multiple panes are to be installed, drill holes in the center of the upper slot at half the width of each pane. Pre-place a pair of wires at each lead-out wire. The length of the wires is 2.5m, and a 300mm gap needs to be reserved in the frame. Generally, it is from the upper hole of the ceiling to the center of the frame or from the pay-off to the control box. Leave a gap of 300mm for the placement.2. When making the frame, pay attention to keeping it and the glass on the same level and perpendicular to the ground. In addition, stick rubber strips around the edge of the inner wall of the frame to keep it stable. When installing dimming glass, pay attention to installing one piece and fix one piece in time. If there are many dimming glasses installed, we need to keep the gap between the glasses consistent, generally between 3-5mm.3. After the glass is installed, we need to connect the power cable of each glass to the power control box. Then fix the upper, lower, left and right blocks, and paste rubber strips on the blocks to make the blocks and the glass tightly connected. Then install and fix the power control box, and check the state of each piece of glass after power-on, and carry out overall debugging. Finally, decorate the outside of the frame and seal the glass gap.If you want to know more about the industry information about the installation process of dimming glass, please log on to our official website and we will bring you more practical knowledge. //txsstx.com